Acclaim Lighting aria Dyna Accent, Руководство пользователя

Страница: 13 / 42

11
www.acclaimlighting.com
FITTING A SNOOT
In installations where any light spill from the Dyna Accent must be eradicated from a nearby
surface, the optional 4” snoot is recommended.
Note: If required, a spread lens can be fitted together with the snoot, see page 10.
TO FIT A SNOOT
Note: This operation is best achieved with the Dyna Accent front face lying horizontal.
1 Using a Phillips screwdriver, slightly loosen each of the four screws that secure the hood
to the main body of the fixture. Once all screws have been suitably loosened, remove all
four of them and lift off the hood.
2 Place the snoot over the Dyna Accent front face in replacement for the hood.
Note: There
are drain holes located every 90 degrees around the snoot circumference, so it can be attached
in any orientation.
3 Fit the four screws and their washers from the original hood and tighten sufficiently.
Snoot