Acclaim Lighting aria Dyna Accent, Руководство пользователя

Страница: 12 / 42

10
www.acclaimlighting.com
FITTING A SPREAD LENS
The standard beam angle is either 5 or 10 degrees, depending on model. These can be
adjusted by inserting an appropriate spread lens into the inside of the front panel.
TO FIT A SPREAD LENS
Notes: This operation is best achieved with the Dyna Accent front face lying horizontally. Install
spread lenses only in dry conditions to avoid any build up of condensation.
1 Using a Phillips screwdriver, slightly loosen each of the four screws that secure the front
hood to the main body of the fixture. Once all screws have been suitably loosened,
remove all four of them and lift off the hood.
2 Remove the protective films from both sides of the spread lens.
3 Ensure that the black rubber gasket is correctly in place around the circumference of the
spread lens. Find the drain recesses on each side of the rubber gasket and ensure that
these are aligned with the two drain holes of the Dyna Accent.
4 Place the hood over the spread lens and Dyna Accent front face, ensuring that the
Drain
hole of the hood aligns with the drain recess in the rubber gasket of the lens.
5 Reintroduce the four screws and tighten sufficiently.
Spread lens
Hood
Drain hole
Drain recess
Drain hole