Acces I/O products E-RDAG12-8, Руководство пользователя, Страница: 23 / 38

RDAG12-8 Manual
Command Description Returns
An=xxx0 W rite xxx0 to DAC n
If the letter A is sent in place of n, all DACs are affected [CR]
An,iiii=xxx0 W rite xxx0 to DAC n buffer entry [iiii] [CR]
An=GOGOGO W rite buffer to DAC n at Timebase rate [CR]
An=STOP Cease writing DAC n buffer to DAC [CR]
S=xxxx or S? Set or read acquisition rate (00A3 <= xxxx <= FFFF) (xxxx)[CR]
ACn=xxx0,dd,tt,mm,
iiii Configure Analog Outputs. See body text. [CR]
BACKUP=BUFFER W rite buffer into EEPROM [CR]
BUFFER=BACKUP Read EEPROM into buffer [CR]
CALn? Read calibration data for n bbbb,mmmm[
CR]
CAL=BACKUP Restore factory calibration [CR]
Caln=xxxx,yyyy W rite calibration values for channel n [CR]
? Command reference for RDAG12-8(H) See Desc.
H Greeting message See Desc.
V Read firmware revision number n.nn[CR]
N Resend Pod’s last transmission See Desc.
POD=xx Assign pod to number xx -:Pod#xx[CR]
BAUD=nnn Set communication baud rate (1 <= n <= 7) =:Baud:0n[CR
]
M xx Set digital mask to xx, 1 is output, 0 is input [CR]
M x+ or M x- Set bit x of digital mask to output (+) or input (-) [CR]
I or In Read the 7 digital input bits, or bit n xx[CR] or
b[CR]
Oxx W rite byte xx to digital outputs (7 bits are significant) [CR]
On+ or On- Turn on or off digital bit n (0 <= n <= 6) [CR]
Table 3-1: RDAG12-8 Command List
Page 3-2
Manual MRDAG12-8H.Bc2