Accent 800 User’s Guide: NuVoice
14
Positioning or Removing the Stand
Do not carry the device by the stand. When carrying the device, use the handle or carry strap.
Positioning the Stand
The stand provides two viewing positions. When latched against the back of the device, the stand provides
a slight angle for viewing the screen when the device is sitting on a flat surface. When you need an
additional angle, extend the legs of the stand away from the back of the device by doing the following:
1.
Place the device face-down on a flat surface.
2.
Rotate the stand away from the back of the device.
3.
Allow the stand to latch in the fully extended position.
Stand latched against
the back of the device
Stand latched in the
fully extended position
Removing the Stand
If you do not want to use the stand, you can remove it from the back of the device. You can reattach it
at any time.
1.
Place the device face-down on a flat surface.
2.
Using a Phillips screwdriver, remove the screws from the holders at the top of each of the stand’s legs.
3.
Pull the holders free and put the holders, screws, and washers in a safe place in case you need to
use them later. Alternatively, you can reinsert the screws and washers in the holes in the device.
Loose holders, screws, and washers could be a choking hazard.
4.
Spread the legs apart to pull them out of the holes in the back of device.
5.
Pull the stand free and put it in a safe place in case you need to use it later.
Important!
If you reattach the stand, be sure to secure the legs with the holders to prevent
someone from pulling it loose accidentally.
Screw and
washer
Note:
A washer is located under
each screw. Be sure to keep the
washers with the screws.