3
SM01P
INSTALLATION
Ensure proper handling and avoid excessive mechanical stress . Do not bend any
components and do not change any insulation distances during transport, handling,
installation or maintenance .
Do not touch any electronic components or contacts . This drive contains electrostatically
sensitive components, which can easily be damaged by inappropriate handling . Static
control precautions must be adhered to during installation, testing, servicing and repairing
of this drive and associated options . Component damage may result if proper procedures
are not followed .
This drive has been tested by Underwriters Laboratory (UL) and is an approved component
in compliance with UL508C Safety Standard .
Warnings!
• Suitable for use on a circuit as described in Section 7 .0 of this manual .
• Use minimum 75°C copper wire only .
• Shall be installed in a Pollution Degree 2 macro-environment .
This drive must be installed and configured in accordance with both national and international
standards . Local codes and regulations take precedence over recommendations provided
in this and other Lenze AC Tech documentation .
The drive is considered a component for integration into a machine or process . It is neither
a machine nor a device ready for use in accordance with European directives (reference
machinery directive and electromagnetic compatibility directive) . It is the responsibility of
the end user to ensure that the machine meets the applicable standards .
ELECTRICAL CONNECTION
When working on live drive controllers, applicable national safety regulations must be
observed . The electrical installation must be carried out according to the appropriate
regulations (e .g . cable cross-sections, fuses, protective earth [PE] connection) . While
this document does make recommendations in regards to these items, national and local
codes must be adhered to .
The documentation contains information about installation in compliance with EMC
(shielding, grounding, filters and cables) . These notes must also be observed for CE-
marked controllers . The manufacturer of the system or machine is responsible for
compliance with the required limit values demanded by EMC legislation .
APPLICATION
The drive must not be used as a safety device for machines where there is a risk of
personal injury or material damage . Emergency Stops, over-speed protection, acceleration
and deceleration limits, etc must be made by other devices to ensure operation under
all conditions .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
