23
SM01P
3 . Use the
button to increase the speed setpoint until the motor starts to rotate . The left
decimal point will light as the speed setpoint is increased . If the
button is held down,
the speed setpoint will increase by tenths of Hz until the next whole Hz is reached,
and then it will increase by one Hz increments . Otherwise, each push of the button
will increase the speed setpoint by a tenth of a Hz .
4 . If the motor is rotating in the wrong direction, give the drive a STOP command and
remove power from the drive . Wait three minutes for the bus capacitors to discharge,
and swap any two of the motor wires connected to U, V, W .
NOTE
The drive is phase insensitive with respect to incoming line voltage . This means
that the drive will operate with any phase sequence of the incoming three phase
voltage . Therefore, to change the motor rotation, the phases must be swapped at
the drive output terminals or at the motor .
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: [email protected]
