Abus WIRELESS ALARM SYSTEM, Руководство по установке

Страница: 93 / 101

10-93
10.2.3 Programming zones
You do not have to program the zones for the detectors in your package. They are already programmed for you as follows:
No. Zone name Zone type Detector type Partition Message
1 Zone 1 Entry(o)Exit (30sec/30sec) Wireless opening contact detector 1 Entrance door
2 Zone 2 Instant Wireless motion sensor 1 Living room
3 Zone 3 Fire Wireless smoke detector 1 Bedroom
•
With this program, the wireless opening detector starts an entry delay of 30 seconds in which your ABUS wireless alarm
system has to be deactivated if it is active. Additionally, you have 30 seconds to leave the object after activating it on the
keypad.
•
The wireless motion sensor is monitored only if the system is completely active. In an internally activated state, the wireless
motion sensor is not monitored so that you can move freely within your object.
•
The wireless smoke detector is always active.
If you have bought other detectors, you have to program them now. See the instructions for further information.
10.2.4 Allocate key-fobs
The key-fob has 4 buttons. To allocate the key-fob:
•
Press
77
.
You are in the key-fob menu option.
•
Press twice. Press
22
followed by .
The system waits for a signal from the remote control.
Press the arm key (closed padlock) and keep it pressed until the system receives the message.
The system acknowledges this with a long beep.
•
Press twice to complete the process. You see the following in the display:
10.2.5 Programming the key fob
You do not have to program the buttons of your remote control. They are already programmed for you as follows:
Button Function
Active (closed padlock) Arm
Inactive (open padlock) Disarm
Small button Panic
Large button Internal arm
If you have bought other remote controls for your package, you have to program them now. See the instructions for further information.
10.3 Enabling voice text transmission by telephone
The telephone transmission function is disabled in the factory since it causes problems if no telephone line is connected. If you want to
transmit voice text by telephone, do the following:
•
Press
55
.
You are in the Dialer menu option.
•
Press
66
followed by
02 02
. Change the setting from [N] to [Y] . Press once. The display changes to [Y] .
•
Press to save your input.
•
Press twice to complete the process. You see the following in the display: