Abus WIRELESS ALARM SYSTEM, Руководство по установке, Страница: 89 / 101

8-89
8.2 Walk test
Under the Walk test menu option, you can test your installation. When the system is in walk-test mode, you can trigger detectors
without setting off an alarm. The walk test mode can be started in two ways:
•
Installer PIN
•
Grand Master PIN
NOTE:
The difference between a walk test started with an installer PIN and a walk test started with the Grand Master PIN is the
way your
ABUS alarm system reacts to a tamper message. If the walk test is started with the installer PIN, there is only a
message on the display in the case of a tamper. If the walk test is started with the Grand Master PIN, there is a message
and an audible alarm.
To conduct a walk test:
1. Make sure that your ABUS wireless alarm system is disarmed
2. Press to access the user menu, followed by
44
to access the Functions menu option.
3. You are prompted to enter a user code (PIN). Enter the 4/6-digit Grand Master PIN or the installer PIN and then
press .
4. Under Functions , press
22
to access the Walk Test menu option. The system issues the following message
“ System in Test Mode” . You see the following on the display:
5. Now trigger all detectors you want to test. After a detector has sent its signal and this is received by your system, the
system confirms receiving the signal by announcing the zone number and name as a local voice message: e.g.
“
Zone 3, dining room”. In addition, all tested detectors appears in a list on your system display.
6. Press to exit walk test mode.
The system issues the following message: “ End of Test Mode”
7. Press to exit the user menu.