Abus HDCC90001, Руководство пользователя

Страница: 65 / 93

Fault rectification
65
Fault rectification
Before contacting the Service department, read the following information to determine the possible cause of any fault.
Fault Cause Solution
No power Power cable not connected Connect the power cable properly to the
socket
Power switch set to OFF Set power switch to ON
No power supplied from socket If necessary, use another device at the
socket
No picture The screen is not set to receive Set correct video input mode, until an image
is received from the recorder
Video cable is not connected properly Connect the video cable properly
The connected monitor is switched off Switch on monitor
No sound Audio cable is not connected properly Connect the audio cable properly
Devices connected via audio cable are not
switched on Check the power supply and power switch
for the connected audio devices
Audio connection cable is damaged Replace cable
Hard disk drive not functioning Connection cable is not connected properly Connect the cable properly
Hard disk drive faulty or incompatible with
the system Replace the hard disk drive with a
recommended hard disk drive
USB connection not
functioning Device is not supported Connect correct USB medium, USB 2.0
USB Hub was used Connect USB medium directly
Network access not possible. Network cable connection loose Insert network cable
Network settings (DCHP, IP address, etc.)
incorrect Check and if necessary correct network
configuration, see page 27.
Recording is not possible No HDD, or HDD not initialised Install and initialise hard disk drive
Sudden switch-off The internal temperature of the device is
too high
Clean the device and/or remove any objects
impeding ventilation