6
EN/US/CA/A.mist A.mistT/UM-2239-1
Subject to alteration without prior notice.
min. 700 mm
TRANSPORT AT SITE / MOUNTING / INSTALLATION
(cont.)
5
5.4 Transporting A•mist
40T
, A•mist
40TF
, A•mist
80T
, A•mist
80TF
The filter unit is delivered on a wooden pallet and is wrapped in plastic foil. The
A•mist
40T
,
A•mist
40TF
and A•mist
80T
filter units
are delivered fully assembled, the A•mist
80TF
is split between
the filter section and the fan section and has to be assembled at the site. To prevent damage,
allow the packaging to remain on the sections until it is time to install them. The filter units
have a high centre of gravity. It is therefore important to secure the filter unit properly to the
transporter before transporting them. If they need to be lifted, do so according to any
of the following methods:
Fig.1 Use an overhead crane
to lift the filter unit stan-
ding on a wooden pallet.
Fig. 2 Use a fork-lift to
lift the filter unit stan
ding on a wooden
pallet.
Fig. 3 Use a fork-lift or an
overhead crane to lift a
filter unit that is standing.
5.5 Floor Mounting
The floor on which the filter unit is placed must be flat and firm. The floor or base must be
designed so that it will support the weight of the filter unit. While mounting the filter unit and
ductwork, tubes and electric cables, allow sufficient open space in front of the service doors
so that they can be opened freely (see pictures below) and that the interior components such
as the filter cassettes can be withdrawn and removed as needed.
Fig. 4: A•mist
6C
,
A•mist
10
,
A•mist
20
,
A•mist
60
Fig. 5: A•mist
40T
,
A•mist
40TF
, A•mist
80T
,
A•mist
80TF
Min 700 mm
Min 27.6 in
Min 650 mm
Min 25.5 in
