ABNOX AXDV-R1 Series, Инструкция по сборке

Страница: 44 / 46

EN
44
Transport damage
If transport damage is found during the receiving inspection, proceed as follows:

Notify the carrier (shipper etc.)

Record the damage

Inform the supplier
Storage
Operation and interim storage in aggressive, damp environments or outdoors may
lead to corrosion and other damage. Maintain the storage temperature in the range of
–20 °C to +40 °C.
Training of personnel
Only trained and instructed personnel that has read and understood all points in the
operating manual is permitted to work on the product. The personnel must also be
able to control the operating states, and identify and implement the interrelated safety
aspects. Personnel in training may only work on the product under the supervision of
qualified personnel.
Troubleshooting, fault resolution
Fault Possible cause Corrective action
Air in the
system
Air pockets in the grease
container
Loosen supply hose. Bleed
system. Reconnect supply
hose.
Air pockets in the hoses
Air pockets in the valve
Metering valve
leak at
discharge Worn stator
Replace stator (see
“Replacing the stator”)
Input pressure too high Reduce input pressure
Leakage from
tell-tale hole
(Fig. G/no. 12)
Defective shaft seal Replace seal
The motor turns
but no lubricant
is ejected
The feed pump is not supplying
lubricant Consult the operating
manual for the feed pump
The connection between the
motor and connecting shaft is
loose Check the connection and
re-tighten the stud screw if
needed
Indicator lamp
does not light
up green
Improper power supply Check power supply
CAUTION
All of the faults described below may only be resolved by trained, qualified
personnel.