| Installation –
Installing the eMH2 Wallbox on the POLEMH2
22
11
Switch to the rear of the opened mounting pole and
pull the supply cable of the wallbox to the terminal
block of the upper top-hat rail.
This completes the installation of the wallbox on the mounting pole. Go to the section “Electrical connection in the
Installing the eMH2 Wallbox on the POLEMH2
This section describes how to install the eMH2 Wallbox on the POLEMH2.
Proceed as follows:
1
Open the housing cover of the wallbox with the
housing cover key and put it aside.
2
Loosen the screw holding the internal electronic
components cover in place using a Torx screwdriver
and put it aside.
y
Keep the screw in a safe place.
3
Use the utility knife to cut an opening for the pow-
er supply cable into the large rubber grommet in the
housing base.
y
For wiring up group installations, you must also
make cuts into the two smaller grommets for the
data cables.
