![background image](http://html1.mh-extra.com/html/abicor-binzel/mag-robo/mag-robo_operating-instructions-manual_451515035.webp)
EN - 15
MIG/MAG ROBO welding torch
9 Maintenance and cleaning
7
For a seamless transition to the contact tip, grind the start of the liner to an angle of approx.
40°. Deburr the cutting edge.
8
Push the tapered liner through the wire conduit to the retaining nipple
(4)
.
9
Screw on the nut
(3)
and tighten it with the switch key wrench.
10
Re-attach the equipment parts to the torch head
(1)
.
9.3 PA liner
1
Use the
ABICOR BINZEL
sharpener
(1)
to sharpen the start of the PA liner to approx. 40°.
2
Guide the PA liner
(3)
through the wire conduit until it reaches the contact tip.
3
Slide the retaining nipple
(2)
, O-ring and nut
(4)
onto the PA liner
(3)
, hold the PA liner taut
and tighten the nut
(4)
.
4
Guide the central connector together with the lengthy PA liner
(3)
through the central socket
into the wire feed unit.
5
Mark the PA liner
(3)
directly in front of the rollers and disconnect the central connector
again.
6
Use the
ABICOR BINZEL
cutter
(5)
to cut off the PA liner
(3)
where marked.
7
Sharpen the interface to 40°.
NOTICE
• New and unused liners must be shortened to the actual length of the cable assembly.
1
ABICOR BINZEL
sharpener
2
Retaining nipple
3
PA liner
4
Nut
5
ABICOR BINZEL
cutter
Fig. 4
Shortening the PA liner
1
2
3
4
5