![background image](http://html1.mh-extra.com/html/abicor-binzel/mag-robo/mag-robo_operating-instructions-manual_451515036.webp)
EN - 16
9 Maintenance and cleaning
MIG/MAG ROBO welding torch
9.4 Cleaning the wire guide
1
Unscrew the cable assembly on the machine side and lay it out in a stretched position.
2
Unscrew the nut and pull out the liner.
3
Clean the wire conduit from both sides with compressed air.
4
Slide the adjusted liner into the wire conduit and secure with a nut.
9.5 Cleaning the torch neck
To increase the system availability of the welding robot,
ABICOR BINZEL
offers automated
torch cleaning.
1
Remove the gas nozzle.
2
Remove the welding spatter and spray with
ABICOR BINZEL
anti-spatter fluid.
3
Check the wear parts for visible damage and replace them if necessary.
4
Replace the equipment kit when worn or soiled.
5
Clean the separating point and O-rings with silicone-free seal grease.
6
Test the TCP in the alignment jig after every use or following a collision.
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide with compressed air, always wear personal protective
clothing, in particular safety goggles.