EN - 9
Welding torch ERGO
8 Maintenance and cleaning
1
Unscrew the cable assembly on the machine side and lay it out in a
stretched position.
2
Unscrew the nut and pull out the liner or PA liner and replace it, if necessary.
3
Remove wear parts from the torch neck.
4
Clean the wire conduit from both sides with compressed air.
5
Mount the liner or PA liner and secure with the nut.
6
Connect the cable assembly on the machine side to the wire feed unit.
NOTICE
• The specified maintenance intervals are guidance values and refer to
single-shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Check the coolant hose, seals and connectors for damage or leaks and
replace if necessary.
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
WARNING
Risk of injury
Serious injuries can be caused by parts swirling around.
• When cleaning the wire guide with compressed air, always wear
personal protective clothing, in particular safety goggles.
