Abicor Binzel Aut-Wig, Руководство по эксплуатации

Страница: 30 / 76

EN - 12
8 Putting out of operation AUT-WIG
7.1 Welding process
1 Open the shielding gas cylinder.
2 Start the welding process.
3 After ignition, hold the welding arc tight to the edge of the material to be
welded until a molten pool is formed.
4 Move the torch uniformly over the entire seam length.
5 Stop the welding process.
6 After switching off, hold the torch over the end position for a few seconds.
The continued flow of gas shields the weld pool, and as the weld pool
solidifies, the result is a bond free from defects.
8 Putting out of operation
1 Wait until the shielding gas flow has subsided.
2 Close the shut-off-valve for the gas supply.
3 Switch off the power supply.
WARNING
Arc burn to the eyes
The arc produced by welding may damage the eyes.
• Wear protective clothing and eye protection.
NOTE
• The welding torch may only be operated by qualified personnel.
• As the TIG welding torch is integrated into a welding system, the
operating instructions of the welding components, such as welding torch
and welding power supply, must be observed during operation.
• For TIG welding, ensure that all the parameters are set at the power
supply for your welding task.