3 XRCG4 startup
XSeriesG4 Remote Controller User's
manual
2103334 Rev. AB
| 55
Start PCCU.
Click
Setup
from the toolbar. The
Setup
screen for communication displays (Figure 52).
Under Communications, select
TCP/IP
as the PCCU connect method.
In the Network ID field type configure one of the following:
a.
The address of the XRC and the TCP port for the connection (in the following format: xxx.xxx.xxx.xxx/TCP port
number).
b.
The IP address of the onsite router/cell modem and the TCP port for the connection (in the following format:
xxx.xxx.xxx.xxx/TCP port number.
Figure 52: Connection setup over Ethernet using non-default TCP port
Click
Close
to exit setup and return to the PCCU main screen
Click
Entry
from the toolbar. When the Entry screen displays, the Ethernet connection over the network is successful.
Setting up the XRC
G4
As previously instructed, once physically connected to the XRC
G4
, the user instructs the host software to connect to the device.
At this time, the software will actually read the device default values programmed at the factory. These preset values are based
on the type of product ordered and are programmed for the most widely used configuration.
Depending on the programming device used, the following are the minimum required entries. Specific information required to
complete each step (depending on the equipment choice) is discussed in the PCCU32 help files.
