BUSCH-/ABB-SECURE@HOME
2CSM600727D0901
68/74
13.2.7
Deleting the events log
To delete the events log:
1.
Carry out points 1 and 2 in the previous section
2.
When the screen appears, enter 6 Events and then confirm.
The control panel deletes all events (critical and secondary) from memory.
WARNING!
Events deletion does not comply with EN 50131-1
13.2.8
Connection
This menu allows you to activate a system maintenance session via the Secure@Home
Manager SW. Before carrying out any of the procedures provided by the SW package (Backup,
Clone, Reset Pin) activate the connection using above menu: a message such as "SW
connection enabled" appears on the display. Then connect the USB cable and follow the
instructions in the SW Secure@Home manual.
13.2.9
Adding devices
To add new devices after the system has been activated, following the instructions for
programming the various devices contained in the Programming chapter.
13.2.10
Deleting devices
To delete a device that is no longer needed:
1.
Log in as a level 2 user, go to the installer screen and log in as a level 3 user: select
Programming.
2.
Select the zone and type of device that you wish to remove, and press OK.
3.
A detailed window will appear, allowing you to check that you have selected the
correct device.
4.
If you have selected the correct device, scroll through all parameters, select "Remove"
at the bottom of the list and press OK to delete.
5.
The control system will ask you to confirm the deletion. Select YES to remove the
device or NO to avoid removing it, and confirm your selection by pressing the OK key.
6.
Press ESC to leave the menu.
13.2.11
Replacing devices
To replace a device, first delete the old device from the system and then add it again.
WARNING!
Deleting a device will result in all configuration parameters being lost. Before
definitively deleting a device, make a note of its parameter values, listed in the
detailed window.
Then, when you add the new device, use the noted values to programme the
parameters.
