ABB RobotWare 6.02, Руководство по применению

Страница: 40 / 52

3.4 Ignition
Overview
Tap the Ignition tab to view or modify the ignition phase parameters.
Note
The ignition phase parameters can only be modified in manual mode.
Tip
To copy the current weld phase mode settings, toggle Use Weld Phase Mode
off, on, and then off again.
Activation/deactivation of Ignition
The Ignition tab is only shown if Ignition is active. It is active if the system parameter
Ignition on (topic PROC , type Miller Arc Equipment Properties ) is set to True.
Interface
xx1500000851
Description Button
The blue refresh button is used to return to the Weld Phase tab. Refresh
The green check button is used to confirm any changes made. Confirm
The red cancel button is used to cancel any changes made and re-
turn to the previous values. Cancel
Continues on next page
40 Application manual - Miller Ethernet I/P Interface and Weld Editor
3HAC054885-001 Revision: -
© Copyright 2015 ABB. All rights reserved.
3 Weld Editor Interface
3.4 Ignition