3.5 Heat
Overview
Tap the
Heat
tab to view or modify heat phase parameters.
Note
The heat phase parameters can only be modified in manual mode.
Tip
To copy the current weld phase mode settings, toggle
Use Weld Phase Mode
off, on, and then off again.
Activation/deactivation of Heat
The Heat tab is only shown if Heat is active. It is active if the system parameter
Heat on
(topic
PROC
, type
Miller Arc Equipment Properties
) is set to True.
Interface
xx1500000852
Description
Button
The blue refresh button is used to return to the Weld Phase tab.
Refresh
The green check button is used to confirm any changes made.
Confirm
The red cancel button is used to cancel any changes made and re-
turn to the previous values.
Cancel
Continues on next page
42
Application manual - Miller Ethernet I/P Interface and Weld Editor
3HAC054885-001 Revision: -
© Copyright 2015 ABB. All rights reserved.
3 Weld Editor Interface
3.5 Heat
Содержание RobotWare 6.02
