![background image](http://html.mh-extra.com/html/abb/reta-01/reta-01_user-manual_209019.webp)
Quick start-up guide
19
Quick start-up guide
Overview
This chapter presents the steps to take during the start-up of the
RETA-01 Ethernet Adapter module. For more detailed information,
see chapters
,
,
elsewhere in this manual.
WARNING!
Follow the safety instructions given in this manual and
the
Hardware Manual
of the drive.
Preliminary preparation
• Before installation of the module, write down the MAC ID of the
module (Printed on a sticker on the back of the module)
• Make sure you have the two screws for fastening the module
Mechanical installation
• Insert the RETA-01 into its specified slot in the drive (SLOT2 for
ACS550, SLOT1 for ACS800).
• Fasten the two screws.
Electrical installation
• Connect the Ethernet cable (RJ-45 connector) to the RETA-01
module. Standard CAT 5 UTP or STP cables can be used.
Avoid parallel runs with power (e.g. motor) cables.
Drive configuration
• Power up the drive. The “MODULE STATUS” LED should be
green. If the network cable is connected to an active network,
the green “LINK/ACTIVITY” LED should also be lit or blinking.
Содержание RETA-01
