ABB IRB 2400/10, Руководство по эксплуатации продукта

Страница: 78 / 227

4 Repair
4.2.1. Performing a leak-down test
3HAC022031-001 Revision: C 76
©
Co
py
rig
h
t 200
4-
200
8 ABB. All righ
ts reser
v
ed.
4.2 General procedures
4.2.1. Performing a leak-down test
General
After refitting any motor and gearbox, the integrity of all seals enclosing the gearbox oil must
be tested. This is done in a leak-down test.
Required equipment
Procedure
Equipment, etc. Art. no. Note
Leakdown tester 3HAC0207-1
Leak detection spray -
Action Note
1. Finish the refitting procedure of the motor or gear in
question.
2. Remove the topmost oil plug on the gear in question,
and replace it with the leakdown tester .
Adapters may be required, which are included in the
leakdown tester kit.
Art. no. is specified in Required
equipment on page 76 .
3. Apply compressed air, and raise the pressure with the
knob until the correct value is shown on the
manometer.
Recommended value:
0.2 - 0.25 bar (20 - 25 kPa)
4. Disconnect the compressed air supply.
5. Wait for approx. 8-10 minutes. No pressure loss must
be detected.
If the compressed air is
significantly colder or warmer
than the gearbox to be tested, a
slight pressure increase or
decrease respectively may occur.
This is quite normal.
6. Was any pressure drop evident?
Localize the leak as detailed below.
Remove the leakdown tester, and refit the oil plug.
The test is complete.
7. Spray suspected leak areas with leak detection spray .
Bubbles indicate a leak.
8. When the leak has been localized: take the necessary
measures to correct the leak.