ABB FlexTrack IRT501 Series, Руководство по эксплуатации продукта

Страница: 64 / 204

2.5 Assembly of the track
2.5.1 Procedure of assembly
General
The FlexTrack IRT 501 should be assembled as set out in the procedure below.
Detailed descriptions of each stage can be found in the following sections.
Required equipment
Tool Qty
Ring-open-end spanner 8-22 mm 1
Socket head cap 2.5 mm, 4 mm, 5 mm, 6 mm, 8 mm and 10 mm 1
Small flat tip screwdriver 1
Plastic mallet 1
Torque wrench 10 Nm -140 Nm 1
Ratchet head for torque wrench 1/2 1
Socket head cap 5 mm, 8 mm, 10 mm socket 1/2” bit L 20 mm 2
Hex head cap 13 mm, 19 mm socket 1/2”bit L 20 mm 2
Picture Specific FlexTrack tools Qty
xx1800001876
Rail Pressing Tool
IRT501-66 & 66R: 3HAW107700358
IRT501-90 & 90R: 3HAW107700456 3
xx1800001877
Rack clamps (3HAW107700357) 3
Continues on next page
64 Product manual - FlexTrack IRT501-66/66R/90/90R
3HAW050008590-001 Revision: C
© Copyright 20042018 ABB. All rights reserved.
2 Installation and commissioning
2.5.1 Procedure of assembly