ABB ACS880-607 Series, Руководство по оборудованию

Страница: 55 / 88

Installation checklist of the drive
Contents of this chapter
This chapter contains a checklist of the mechanical and electrical installation of the drive.
Checklist
Examine the mechanical and electrical installation of the drive before start-up. Go through
the checklist together with another person.
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death, or
damage to the equipment can occur.
If you are not a qualified electrician, do not do installation or maintenance work.
WARNING!
Stop the drive and do the steps in section Electrical safety precautions (page 38)
before you start the work.
Make sure that …
The ambient operating conditions (including free space around the drive) meet the specifications.
The drive cabinet has been attached to floor, and if necessary due to vibration etc, also by its top to
the wall or roof.
The cooling air flows freely in and out of the drive.
If the drive is connected to a network other than a symetrically grounded TN-S system: Check the
compatibility. See the electrical installation instructions in the supply unit manual.
There is an adequately sized protective earth (ground) conductor between the drive and the switchboard,
the conductor has been connected to appropriate terminal, and the terminal has been tightened. (Pull
on the conductor to check.) Proper grounding has also been measured according to the regulations.
7
Installation checklist of the drive 55