■
Fieldbus control
You can control the unit through a fieldbus interface if the unit is equipped with an optional
fieldbus adapter (for example, K454), and when you have configured the control
program for the fieldbus control with the parameters. For information on the parameters,
see the firmware manual.
Note:
To be able to switch the main breaker [Q1] and the supply unit on and off (Run enable
signal) through the fieldbus, the Run enable command at digital input DI2 must be on (1).
That is the case when the operating switch [S21] is switched to the ENABLE/RUN position.
Type designation labels
Each diode supply module and unit has a type designation label. The type designation
stated on the label contains information on the specifications and configuration of the unit.
Supply unit
1
2
3
4
5
6
7
8
Type designation
1
Frame size
2
Cooling method
3
Degree of protection
4
UL/CSA data
5
Ratings
6
Valid markings
7
Serial number. The first digit of the serial number refers to the manufacturing plant. The next four digits
refer to the unit’s manufacturing year and week, respectively. The remaining digits complete the serial
number so that there are no two units with the same number.
8
28 Operation principle and hardware description
Содержание ACS880-307LC
