■
Replacing the cooling fan of a D8T supply module
WARNING!
Use the required personal protective equipment. Wear protective gloves and long
sleeves. Some parts have sharp edges.
1.
Repeat the steps described in section
Electrical safety precautions (page 36)
.
2.
Remove any shrouding in front of the cooling fan.
3.
Remove the support bracket of the fan.
4.
Disconnect the fan wiring.
5.
Undo the two retaining screws.
6.
Pull the fan outwards to separate it from the heat exchanger housing.
7.
Install new fan in reverse order. Align the guide pins at the rear of the fan cowling with
the slots in the bottom guide, then reinstall the retaining screws.
3
4
5
7
Maintenance 67
Содержание ACS880-307LC
