ABB ACS880-04FXT, Руководство по оборудованию

Страница: 67 / 196

100 200 300
0.0
0.5
1.0
1.5
2.0
2.5
3.0
/---- (1/
µ
s)
U
N
---
u
--- -d-
t
-
d
l (m)
Û
LL
/
U
N
A
Û
LL
/
U
N
l (m)
d
u
/d
t
U
N
-------------(
1/ µ s
)
1.0
2.0
5.0
4.0
3.0
1.5
2.5
3.5
4.5
100 200 300
5.5
B
Drive with d u /d t filter A
Drive without d u /d t filter B
Motor cable length I
Relative peak line-to-line voltage Û
LL
/ U
N
Relative d u /d t value (d u /d t )/ U
N
Note: Û
LL
and d u /d t values are approximately 20% higher with resistor braking.
Additional note for sine filters
A sine filter also protects the motor insulation system. The peak phase-to-phase voltage
with a sine filter is approximately 1.5 ·
U
N
.
Selecting the power cables
￭ General guidelines
Select the input power and motor cables according to local regulations.
• Current: Select a cable capable of carrying the maximum load current.
• Temperature: For an IEC installation, select a cable rated for at least 70 °C (158 °F)
maximum permissible temperature of conductor in continuous use. For North America,
select a cable rated for at least 75 °C (167 °F).
• Voltage: 600 V AC cable is accepted for up to 500 V AC. 750 V AC cable is accepted
for up to 600 V AC. 1000 V AC cable is accepted for up to 690 V AC.
To comply with the EMC requirements of the CE mark, use one of the preferred cable types.
See
Preferred power cable types (page 68) .
Symmetrical shielded cable reduces electromagnetic emission of the whole drive system
as well as the stress on motor insulation, bearing currents and wear.
Metal conduit reduces electromagnetic emission of the whole drive system.
The protective conductor must always have an adequate conductivity.
Unless local wiring regulations state otherwise, the cross-sectional area of the protective
conductor must agree with the conditions that require automatic disconnection of the supply
required in 411.3.2. of IEC 60364-4-41:2005 and be capable of withstanding the prospective
Guidelines for planning the electrical installation 67