ABB ACS880-04FXT, Руководство по оборудованию

Страница: 103 / 196

A PC (with eg, the Drive composer PC tool) can be connected as follows:
1. Connect an ACx-AP-x control panel to the unit either
• by inserting the control panel into the panel holder or platform, or
• by using an Ethernet (eg, Cat 5e) networking cable.
2. Remove the USB connector cover on the front of the control panel.
3. Connect an USB cable (Type A to Type Mini-B) between the USB connector on the
control panel (3a) and a free USB port on the PC (3b).
4. The panel will display an indication whenever the connection is active.
5. See the documentation of the PC tool for setup instructions.
?
Start Stop
Loc/Rem
?
Start Stop
Loc/Rem
USB connected
3a
4
3b
2
2
Installing optional modules
￭ Installation of BCU control unit
See BCU-02/12/22 control units hardware manual (3AUA0000113605 [English]).
￭ Installation of an FSO-xx safety functions module onto BCU
WARNING!
Obey the instructions in chapter Safety instructions. If you ignore them,
injury or death, or damage to the equipment can occur.
This procedure describes the installation of an FSO-xx safety functions module onto the
BCU control unit. (The FSO-xx can alternatively be installed beside the control unit, which
is the standard with factory-installed FSO-xx modules. For instructions, see the FSO-xx
manual.)
1. Stop the drive and do the steps in section Electrical safety precautions (page 15) before
you start the work.
2. The FSO-xx comes with alternative bottom plates for mounting on different units. For
mounting on the BCU, the mounting points should be located at the long edges of the
module as shown. Replace the bottom plate of the FSO-xx if necessary.
Electrical installation 103
11