ABB ACS850-04 series, Руководство по оборудованию

Страница: 22 / 164

Introduction to the manual
22
Start-up refers to the start-up instructions of the cabinet-installed drive.
Fault tracing describes the LED indications and refers to the fault tracing instructions
of the drive.
Maintenance contains preventive maintenance instructions.
Technical data contains the technical specifications of the drive module, eg, the
ratings, sizes and technical requirements, provisions for fulfilling the requirements for
CE and other markings.
Dimension drawings contains dimension drawings of the drive module installed into
a Rittal TS 8 cabinet.
Example circuit diagram shows an example circuit diagram for a cabinet-installed
drive module.
Resistor braking describes how to select, protect and wire brake resistors.
du/dt filters describes how to select d u /d t filters for the drive.
Categorization by frame size and option code
The instructions, technical data and dimension drawings which concern only certain
drive frame sizes are marked with the symbol of the frame size (G1 or G2). The
frame size is marked on the type designation label.
The instructions and technical data which concern only certain optional selections
are marked with option codes, eg, +H381. The options included in the drive can be
identified from the option codes visible on the type designation label. The option
selections are listed in section
Type designation key on page 35 .
Quick installation, commissioning and operating flowchart
Task See
Plan the installation.
Check the ambient conditions, ratings, required
cooling air flow, input power connection, compatibility
of the motor, motor connection, and other technical
data.
Select the cables. Planning the cabinet installation (page 37 )
Planning the electrical installation (page 49 )
Technical data (page 125 )
Resistor braking (page 155 )
Option manual (if optional equipment is
included)
Unpack and check the units.
Check that all necessary optional modules and
equipment are present and correct.
Only intact units may be started up. Moving and unpacking the unit (page 74 )
Checking the delivery (page 76 )
If the drive module has been non-operational
for more than one year, the converter DC link
capacitors need to be reformed. (
Reforming the
capacitors , page 124 )