ABB ACH550-01, Руководство пользователя

Страница: 148 / 454

136 Serial communications
ACH550 User's Manual
The new settings will take effect when the drive is next powered
up, or when parameter 5127 is activated.
Drive control parameters
After the fieldbus communication has been set up, the drive
control parameters listed in the tables below should be checked
and adjusted where necessary.
The “Setting for fieldbus control & description” column gives the
value to use when the fieldbus interface is the desired source or
destination for that particular signal as well as a description of
the parameter.
The fieldbus signal routes and message composition are
explained later in section
Fieldbus control interface .
5131 FBA STATUS 0…6
Contains the status of the adapter module.
0 =
IDLE
– Adapter not configured.
1 =
EXEC
.
INIT
– Adapter is initializing.
2 =
TIME OUT
– A time-out has occurred in the communication between
the adapter and the drive.
3 =
CONFIG ERROR
– Adapter configuration error.
• The major or minor revision code of the adapter’s CPI firmware
revision differs from that stated in the drive’s configuration file.
4 =
OFF
-
LINE
– Adapter is off-line.
5 =
ON
-
LINE
– Adapter is on-line.
6 =
RESET
– Adapter is performing a hardware reset.
5132 FBA CPI FW REV 0…0xFFFF
Contains the revision of the module’s CPI program. Format is xyz,
where:
• x = major revision number
• y = minor revision number
• z = correction number.
Example: 107 = revision 1.07
5133 FBA APPL FW REV 0…0xFFFF
Contains the revision of the module’s application program. Format is
xyz, where:
• x = major revision number
• y = minor revision number
• z = correction number.
Example: 107 = revision 1.07
Code Description Range