ABB 888-2, Руководство по применению

Страница: 38 / 88

4.3 Configuring the internal device
General
The internal device is pre-installed at the system startup. However, the input and
output size of the device can be changed. The size of the internal device determines
how many signals that can be attached, see
Input and output size on page 30 .
This section describes the recommended working procedure of configuring a
internal device. The working procedure helps to understand the dependencies
between the different steps.
Note
It is only possible to have one internal device.
Internal device configuration
Use this procedure to create and configure the internal device in the IRC5 controller,
using RobotStudio.
Note Action
Start RobotStudio and connect to the
IRC5 controller. Request write access. 1
For more information about the paramet-
ers, see
System parameters on page 49 .
Open the Configuration Editor and select
I/O System .
2
xx1400002056
In the Type list, click PROFINET Internal
Device , right-click in the workspace and
select PROFINET Internal Device .
Edit the parameter values for the internal
device, if applicable.
• Change the default values for Input
Size and Output Size to the de-
sired size.
Note
This step is optional, for more in-
formation see
Input and output size
on page 30 .
Click OK .
3
In the Type list click Signal . 4
Add I/O signals for the internal device.
Restart the controller. 5
38 Application manual - PROFINET Controller/Device
3HAC050969-001 Revision: G
© Copyright 2015-2018 ABB. All rights reserved.
4 Configuring the internal device and external controller
4.3 Configuring the internal device