•
The engineering steps are protocol dependent.
•
Use the communication management tool (CMT) for DNP3 engineering.
•
Use the IET600 station configuration tool for IEC 61850 engineering.
See the application manual for other protocols (IEC103).
The IED restarts automatically when writing an IED configuration
where changes have been made to, for example, configuration
parameters. It is not possible to communicate with the IED during
the restart.
The IED does not restart after reconfiguring IEC61850 (regardless
of whether the protocol is enabled or disabled prior to
reconfiguring). The IED will reboot at the next PCM600 to IED
write operation only in case there are errors while configuring the
IEC61850 protocol at the most recent attempt.
1MRK 511 261-UEN -
Section 3
Engineering process
650 series
21
Engineering Manual
