Optigo OP10 user manual
Chapter 9
Clock and scheduler
26
Chapter 9 Clock and scheduler
The menus for setting the clock and the scheduler times lie in the 3-seconds level. This level is accessed from the basic
level by clicking and holding the encoder knob for 3 seconds.
Real time clock
This sample display shows that the time is 13:48 on a Friday, the fifth day of the week.
The 0.0 in the top right corner is a menu display counter. Each configuration menu has a
unique number combination. All menus connected to the clock and scheduler belong to the
group 0.
To set the clock, click the knob and the day-of-the-week number will start flashing. Twist the
knob until the correct day is shown, Monday is 1, Tuesday 2 etc, and then click the knob
again to acknowledge the choice. Now the hours will flash. Set them in the same way and
then finally the minutes. After confirming the minutes the menu will change to show the first
of the scheduler menus.
Note
The clock does not have automatic summertime adaption.
Scheduler, general
The scheduler function is only available for control modes 1, 2, 3 and 4.
The easiest way to understand the scheduler function is to compare it to the type of
mechanical timer that has a rotating disk where you can pull out knobs that on passing the
switch kan turn it ON or OFF. There are 4 ON-points and 4 OFF-points. Each point has its
own menupage where 0.1, 0.3, 0.5 and 0.7 are ON-points and 0.2, 0.4, 0.6 and 0.8 are OFF-
points.
Control modes 1, 2 and 3 have the same type of scheduler where the ON-points will start the
unit and the OFF-points will shut it down.
Control mode 4 uses the scheduler for switching to economy mode (ECO) where the
temperature is lowered by a settable number of degrees. Here the ON-points will switch
ECOnomy period on and the OFF-points will switch back to comfort temperature.
Scheduler, control modes 1, 2 and 3
Menus 0.1 – 0.8
With the 4 pairs of on-off menus you can create 4 different running periods, either for single
days or for a group of days. The day of the week number can be set to any value 1 to 9 or
-- for unused menus.
Numbers 1 to 7 represent the days of the week Monday to Sunday. Number 8 will apply the
set time every day Monday through Friday and number 9 will apply the set time all 7 days of
the week.