AAF PulsePak Prime 10-2H, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 38

8 PulsePak Prime
GDED-IOM-216-B
erected to prevent the parking of vehicles, pedestrian use, or use of the area for
temporary storage. Warning signs shall be posted. Include diagrams showing the
distribution of a typical dust explosion discharge.
2.4 Electrical hazards
Before doing any work on the AAF equipment, make sure that all potential
electrical hazards have been identified and that all electric current connected to the
equipment, and to any connected or associated equipment, has been properly
disconnected and securely locked-out to prevent accidental reconnection prior to
completion of the work. All electrical work shall be done in full accordance with the
current edition of NFPA 70, the National Electrical Code, and all other applicable
laws, rules, and regulations. All electrical work shall be performed by a licensed
electrician. Only original AAF parts shall be used as replacements for ongoing
maintenance and repair.
2.5 Rotating equipment
The PulsePak Prime can include a fan which is installed with the dust collector.
The fan wheel rotates and has the potential to cause severe injury. The fan wheel
could be accessed from outside the housing through the fan discharge. All due care
should be exercised to avoid any contact with the operating fan. Under no
circumstances should the fan ever be allowed to operate when any of the access
panels on the dust collector, or the silencer, have been removed. The fan must be
disconnected and locked out prior to the performance of any maintenance work, see
paragraph 2.4.
2.6 Safety guards
The dust collector ductwork prevents access to the fan inlet. All access panels
shall remain bolted in place while the fan is operating. Prior to the removal of any
access panels, the electrical power to the collector shall be disconnected and locked
out, see paragraphs 2.4 and 2.5. After electrical power is disconnected, the fan
wheel will continue to rotate for a period of time before coasting to a stop. Do not
access the fan until the fan wheel has come to a complete stop.