AAF PulsePak Prime 10-2H, Инструкция по установке, эксплуатации и обслуживанию

Страница: 24 / 38

24 PulsePak Prime
GDED-IOM-216-B
The compressed air connection should be made at the top of the air manifold
on each module where a 1” NPT pipe connection is supplied. There is also a
connection at the bottom of the air manifold to attach a drain.
9.2.11 Ductwork Installation
Install the inlet ductwork to the front inlet above the access doors. Connect
the clean air duct (or manifold) to outlet(s) located on the bottom and rear side of
the clean air plenum.
Ductwork should be of sufficient gauge to withstand the system design
pressure and should be independently supported.
The PulsePak Prime is not designed to support ductwork.
10 EXPLOSION VENTS
The following only applies to AAF-supplied explosion vents. Additional and/or
different steps, equipment, etc. may be needed for vents and other equipment not
supplied by AAF. Further, the following is a non-exhaustive list of recommendations,
and users must carefully read, among other things, the manufacturer’s explosion
vent guide for further instructions.
10.1 Installation of the explosion vent
If an explosion vent is ordered with the PulsePak Prime, the explosion vent is
shipped separately from the collector. Ensure no damage has been done to the
explosion vent during shipping or handling.
The PulsePak Prime will have a frame constructed as part of the unit where
the explosion vent is mounted. The number of explosion vents and location of the
explosion vent will be detailed on the collector drawing.
10.2 Assembly
Ensure no damage has been done to the explosion vent during shipping or
handling. The PulsePak Prime will have a frame constructed as part of the unit where
the explosion vent is mounted. The number of explosion vents and location of the
explosion vent will be detailed on the collector drawing.
Gripping the opposite sides, carefully remove the explosion vent from the
crate that it was shipped. Avoid excessive flexure of the explosion vent while
handling.