a2b Orsted, Руководство по эксплуатации

Страница: 55 / 80

55
6.5.3 LED indications during charging process
The following table shows the battery's LED indications during the
charging process.
While in operation or in case of storage
• 100-81% ROC: LED1-LED5 continuously illuminated
• 80-61% ROC: LED1-LED4 continuously illuminated
• 60-41% ROC: LED1-LED3 continuously illuminated
• 40-21% ROC: LED1-LED2 continuously illuminated
• 20-11% ROC: LED1 continuously illuminated
• 10-0% ROC: LED1 flashing
During charging
• 100% ROC: LED1-LED5 continuously illuminated
• 99-81% ROC: LED1-LED4 continuously illuminated
• 80-61% ROC: LED1-LED3 continuously illuminated
• 60-41% ROC: LED1-LED3 continuously illuminated
• 40-21% ROC: LED1-LED2 continuously illuminated
• 20-11% ROC: LED1 continuously illuminated
• 10-0% ROC: LED1 flashing
If a fault occurs during the charging process, all LEDs will
illuminate. Check if all criteria (such as ambient temperature,
properly fixed charging plug, etc.) relating to the charging process
have been fulfilled in accordance with the present operating
instructions and those enclosed with the charger.
Do not leave the charger connected to the mains after the
charging process
is finished. After the end of the charging process, the charger must
first be disconnected from the mains socket and then from the
battery pack.
Always check the battery pack's state of charge before
starting a journey. It should be fully charged before starting the
journey so that motorised assistance is available at any time.
The batteries may only be charged in a dry room at a
temperature between 0°C and a maximum of 40°C.
Observe the information in the operating instructions
enclosed
with the charger.
Follow the safety instructions and warnings relating to
the battery provided in sections 2.1 to 2.5 of these operating
instructions