a2b Orsted, Руководство по эксплуатации

Страница: 40 / 80

User manual
5.5.2 Attaching the drive wheel
Make sure that all components fixed to the
wheel have been mounted according to
their respective manufacturer's instructions
and specifications. This applies in particular
to the brakes and the gear box. Do not
forget to remount the torque support [20] in
the same position as before removal.
Then, push the wheel into the slot on the
frame and tighten it using the hub axle nut
[18] in the following sequence:
• first tighten on the gear box side (figure
A)
• then tighten on the brake side (figure B)
The tightening torque of the two nuts is
between 30 and 40 Nm in each case.
Make sure that the tooth lock washer [19]
is under the hub axle nut, otherwise there is
the risk that the hub axle nut [18] can come
loose.
If your wheels are equipped with quick
releases, please observe the manufacturer's
specifications on mounting and the
tightening torque.
If the wheel is correctly fixed to the frame,
the motor can be connected to the cable
end leading to the battery. While doing
so, ensure that the plug [15] is correctly
aligned with the socket [17]. The rounded
surfaces ([A] and [B]) must be aligned with
each other!
Fasten all cables and supply lines to the
bicycle frame using cable fixers and carry
out a final functional test.
Make sure the cable is installed correctly
since the cable could get caught in the
brake disk, drive or spokes if the cable
is incorrectly installed, leading to wheel
locking and, subsequently, the rider falling
off.
Observe the manufacturers'
instructions and specifications for the
various components fitted to the wheel at all
times during mounting work. This applies in
particular to the brake, the gear box and the
quick release.
A
B