A-T Controls Triac TMC-4, Инструкция по установке и эксплуатации

Страница: 4 / 24


TMC-4 Control Card
for Electric Actuators
Installation & Maintenance Manual
4 04/06/22
www.atcontrols.com IOM08139 REVISION 04
11 – Joystick
5-way joystick (up, down, left, right, center) for menu
navigation and adjustment of parameters and settings.
Direction Function
UP ▲
[PREVIOUS]

Navigate up in menus.

Choose previous setting selection or
increase setting value.

Motor CCW in Manual Mode or POSITION
CONFIG calibrate settings.
DOWN ▼
[NEXT]

Navigate down in menus.

Choose next setting selection or decrease
setting value.

Motor CW in Manual Mode or POSITION
CONFIG calibrate settings.
LEFT ◄
[CANCEL]

Navigate left in menus.

Return to previous menu screen or exit
menu subgroup.

Cancel or exit setting without saving.
RIGHT ►
or
CENTER
◙
[CONFIRM]

Navigate right in menus.

Enter parameter screen to adjust setting.
Parameter value will flash indicating it can
be changed.

Confirm or save setting when finished
changing.
NOTE: When incrementing/decrementing a setting value, the
value step increases in value every 6 presses for more rapid
adjustment. Reset the step back to +1 by pressing back in
opposite direction.
12 – Display
OLED screen to show actuator status and menu options.
Display will enter a sleep mode where the display is shut
off if joystick has not been used for 5 minutes. Remote
functionality is still enabled while in sleep mode. Status
LED will flash while in sleep mode. Pressing any
direction on joystick will wake up display.
13 – LEDs
Status: Flashes 1 second on when in Sleep Mode.
Power: Solid to indicate the TMC4 is powered
either by the supply terminals, or through
the USB connector.
USB: Solid to indicate USB cable is connected to
the micro USB connector.
14 – Run/Program Switch
Used by factory for programming and setup. Switch
should be in off position (pointed away from USB
connector) for normal operation.
15 – USB Connector
Micro USB receptacle. Used by factory for programming
and setup. Can be used to power board for configuration
without having supply power connected.
1.1. Dimensions
UP ▲
(PREVIOUS)
DOWN ▼
(NEXT)
LEFT ◄
(CANCEL)
RIGHT ►
(CONFIRM)
CENTER
◙
(CONFIRM)