A.R.C. Laser CLASSIC 514, Руководство пользователя

Страница: 32 / 56

User Manual CLASSIC 514
August 2023
File: User Manual_CLASSIC 514_rev5.docx 32
6.6 Release laser radiation
To trigger the laser, press the trigger on the vertical drive
(joystick) of the slit lamp. For that, the laser must be switched to
the READY mode. Alternatively, the CLASSIC 514 can be
trigged by a foot switch.
When a laser shot is fired, a simultaneous warning signal
sounds and the red LED of the Fiberport lights up.
6.7 Treatment
Position the patient´s chin on the chin rest. Make sure that the patient only touches the
application parts. The application parts are the chin rest including handles. Make sure
that you and the patient do not touch any other parts at the same time.
Adjust the position of the slit lamp, slit lighting, focus and contact glass as required.
Choose your initial values for the laser energy. It is always good to start at a low level
and then increase energy to the target during treatment.
Fix the patient's eye with a contact glass and focus the target beam into the eye to be
treated.
Select the necessary beam intensity. At this point, you should see that the target point is
in focus with the microscope.
Press the READY button: the yellow LED flashes for some seconds and then changes to
steady light. Treatment can start.
The software of the CLASSIC 514 sums up the number emitted shots, which is
permanently shown in the lower area of the display.
At the end of a treatment, press the READY button. The trigger does not work in this
position.
After setting the first treatment values, it is advisable to first set a laser pulse in the
periphery of the retina, or the treatment area, in order to observe the laser effect. Under
no circumstances should the first laser pulse be placed centrally or close to the macula.
A T T E N T I O N
Any serious incident that occurrs with this laser must be reported to the A.R.C. Laser
GmbH and the responsible state authority.