22
*NOTE:
The target site can be a Domain Name, IP Address or even LAN IP
Address – e.g. the router’s IP or local device on the router such as an IP
Camera. Your Router IP will be filled in automatically and is meant
for cases
where user want to ensure that an Auto Reset event is only due to Router
crashing, and not just a failure of external IPs.
Heartbeat:
This feature is an alternative to using the Website/ IP addresses for UDP/
TCP Ping requests. An HTTP command will be sent instead
Assign
Select
None
to disable this setting (default); OR
Select a single outlet or
BOTH
outlets to control what is reset upon no response.
Timeout Within
Set the time that the HTTP command must respond within. If it does not respond
within this time, the outlet(s) will be reset.
ii.
Outlet Setup
Outlet 1/ 2 Name:
Apply a name to easily identify the connected device (e.g. router, modem, etc).
Normal
vs
Reset:
If user wants to have manual ON/ OFF control while the UIS Auto Reset is enabled,
select
Normal
. If user wants to ensure the outlet(s) are not turned off remotely by
mistake, set
Reset Only
.
Power-on Delay for Outlet 1:
Apply a delay (Power Off > Delay > Power On) to Outlet 1 power-cycle sequence.
Default is 3 seconds– configurable from 1-600 seconds
.
Power-on Delay for Outlet 2:
Apply delay to Outlet 2, which takes place after Outlet 1 is reset. In default
configuration, Outlet 2 resets 13 seconds after Outlet 1.
Default 10 seconds –
configurable from 1-600 seconds.
