VISIX SOLUTIONS | VX-2S-OP-30X QUICK START GUIDE | p.8
2.3.2
CORNER MOUNT INSTALLATION
Before you start:
The corner mount is intended to be installed solid 90-degree corners. The following are the mandatory preconditions
for corner mounting:
n
The wall must be thick enough to install the expansion screws.
n
The wall must be strong enough to withstand more than 8 times the weight of the dome and its
accessories.
Steps:
1.
Install the corner adapter.
Steps:
(1)
Drill four holes in the corner according to the screw holes of the corner adapter, and then insert M8
expansion screws (not supplied) into the holes.
(2)
Pull the cables through the center hole of the corner adapter.
(3)
Attach the corner adapter to the corner by aligning the 4 screw holes of the corner adapter with expansion
screws on the corner.
(4)
Secure the corner adapter to the corner with the nuts and washers to tighten the four expansion screws.
Figure 1-1
Pull the Power Line
NOTE:
Make sure that the cables have enough length. For outdoor applications, please apply the sealant around the
center hole for waterproof.
2.
Attach the gasket then the wall mount to the corner adapter.
3.
Secure the wall mount to the corner adapter with 4 hex screws and spring washers.
NOTE:
When tightening the screw, it is better to compress the spring washer tightly first and then rotate it half-turn
to ensure water-proofing without damaging the threads.
Nuts and Washers