DOCUMENT
OBSOLETE
7
78-8125-3042-2-B
13. Insert a module body between the vertical
side posts above the index strip. Push down on the
module body to lightly engage the index strip.
Ensure the cathedral windows and latches face the
operator/front.
14. Position the “T” bar upright above the module
body between the vertical side posts. Apply down-
ward pressure to the “T” bar until contact with the
module body is made. Pull the handle all the way
down until it hits the stop to seat and lock the
body into the index strip.
15. Secure the 25 pair group through the second
conductor group holder and dress individual pairs
into the cathedral windows of the module body.
Note: The conductors must lay through the mod-
ule body straight and must not be pulled tight.
16. Check for color code dressing errors with the
error tester. (fig. 4 #2) With the error tester to the
left, between the vertical posts all tip conductors
are visible. With the tester to the right all ring
conductors are visible. Any errors can be detected
and corrected.
17. Spread the conductors evenly to each side of
the “T” bar without pulling or disturbing the con-
ductors position in the module body. Position the
“T” bar in an upright position above the module
body between the vertical side posts. Apply for-
ward and downward pressure to the “T” bar until
contact with the body is made.
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
