DOCUMENT
OBSOLETE
6
78-8125-3042-2-B
7. Check for wire color code dressing errors with
the error tester (fig. 4 #2). With tester to the left,
between the vertical posts all tip conductors are
visible. With the tester to the right, all ring con-
ductors are visible. Any errors can be detected and
corrected.
8. Spread the conductors evenly to each side of
the “T” bar without pulling or distributing the
conductors position in the index strip.
9.
Position the “T” bar upright above the index
strip between the vertical side posts. (fig. 1 #2)
10. Apply downward pressure to the “T” bar until
contact with the index strip is made.
11. With the “T” bar in contact with the index strip,
push the “T” bar forward and downward, then pull
the handle all the way down until it hits the stop
position. This action firmly seats the conductors on
the index strip while the blade cuts the excess con-
ductors. Remove the surplus conductors with the
handle in the down position.
12. With the conductors seated and cut, return the
handle to the upright and engage it firmly within
the handle retaining clip. (fig. 2 #1) Position the
“T” bar clear of the module assembly area.
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
DOCUMENT
OBSOLETE
