3M Pentamix 2, Руководство по обслуживанию

Страница: 24 / 33

Vers. (11/02)
Pentamix
TM
2
19
Pentamix TM 2
5.18 Side Right
Changing side right
1. Remove plunger discs - see section 5.2
2. Remove case base - see section 5.3
3. Remove both sides - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove mixer shaft - see section 5.6
6. Remove case top section - see section 5.7
7. Disconnect power cable from PC board and remove
8. Remove Allen screws connecting bottom plate on right-hand side
9. Remove recessed-head screw connecting endpiece
10. Remove connection to bearing plate for mixer motor
11. Slightly lift right side
12. Remove deflection roller and chain
13. Lift off right side
14. Remove screws for fixing PC-board
15. Install new right side in reverse order
16. Check shut-off point - see section 5.19
17. Assembling housing - see section 5.20
18. Functional test - see section 6
5.19 Shut-Off Point
Instructions for adjusting shut-off point
1. Remove plunger discs - see section 5.2
2. Remove base - see section 5.3
3. Remove both side covers - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove mixer shaft - see section 5.6
6. Remove case top section - see section 5.7
7. Loosen recessed-head screw at rider
8. Push traverse towards endpiece until the distance between the traverse and
endpiece measures 29,5 ± 0.5 mm
9. Slide the rider until a click is heard
10. Tighten recessed-head screw
11. Recheck switching point by listening for click when traverse is moved and distance
of 29,5 ± 0.5 mm is reached
12. Assembling housing - see section 5.20
13. Functional test - see section 6