3M Pentamix 2, Руководство по обслуживанию

Страница: 20 / 33

Vers. (11/02)
Pentamix
TM
2
15
Pentamix TM 2
5.12 Traverse
Changing traverse
1. Remove plunger discs - see section 5.2
2. Remove case base - see section 5.3
3. Remove both side covers - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove mixer shaft - see section 5.6
6. Remove case top section - see section 5.7
7. Slide forward both traverse covers to remove
8. Move cross-member to reveal the recessed-head screws fixing the chains to the
traverse in the bore
9. Remove recessed-head screws
10. Loosen left side - see section 5.11
NOTE
Left side should only be loosened and not removed completely
11. Remove traverse
12. Fit new traverse in reverse order
13. Check shut-off point - see section 5.19
14. Assembling housing - see section 5.20
15. Functional test - see section 6
5.13 Drive Shaft
Changing drive shaft
1. Remove plunger discs - see section 5.2
2. Remove case base - see section 5.3
3. Remove both side covers - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove mixer shaft - see section 5.6
6. Remove case top section - see section 5.7
7. Move traverse to reveal the recessed-head screws fixing the chains to
the traverse in the bore
8. Remove recessed-head screws
9. Remove left side - see section 5.11
10. Remove cable ties
11. Release feed motor leads from terminal strip of PC board
12. Release connection to bearing plate for mixer motor
13. Remove deflection roller with chain
14. Remove drive shaft
15. Install new drive shaft in reverse order
16. Check shut-off point - see section 5.19
17. Assembling housing - see section 5.20
18. Functional test - see section 6