3M Pentamix 2, Руководство по обслуживанию

Страница: 18 / 33

Vers. (11/02)
Pentamix
TM
2
13
Pentamix TM 2
5.8 Power Switch
Changing power switch
1. Remove plunger discs - see section 5.2
2. Remove case base - see section 5.3
3. Remove both side covers - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove mixer shaft - see section 5.6
6. Remove case top section - see section 5.7
7. Remove power switch from its mounting
8. Mark leads of power switch and unsolder
CAUTION
The snap lock must be removed from the new power
switch:
Push the bottom of the helical compression spring back
until the snap lock can be removed.
CAUTION
Before installing the new power switch the soldering tags
should be cut off without making a hole flush with the rear
of the power switch using side nippers.
9. Install new power switch in reverse order
10. Assembling housing - see section 5.20
11. Functional test - see section 6
5.9 Power Cable
Changing power cable
1. Remove plunger discs - see section 5.2
2. Remove base - see section 5.3
3. Remove both side covers - see section 5.4
4. Remove case bottom section - see section 5.5
5. Remove clamping screws of power cable on PC board
6. Remove power cable
7. Fit new power cable in reverse order
CAUTION
Recheck that wiring is correct, in particular the
yellow & green protective conductor (US: green).
8. Assembling housing - see section 5.20
9. Functional test - see section 6