20
CT150 FPD Monitors
3M Touch Systems Proprietary Information
2.
Make sure the video image is displayed. If it is not, check the LED to
ensure that the monitor is not in power save mode (flashing
orange/red). If the LED is not on, turn on your monitor.
3.
Make sure the video image is centered within the screen area. Use the
monitor controls to adjust the image, if necessary.
You can adjust the horizontal and vertical position, contrast, and
brightness to better suit your video card and your personal
preference. Refer to Chapter 4 for more information on using the
on-screen menu to adjust the video display.
Installing MicroTouch Software
Two versions of touch software are included on the CD packaged
with your monitor. We strongly recommend you read the
README.TXT before you begin any software installation.
Windows
2000
Windows
XP
Windows
9x
Windows
NT Controllers
TouchWare
5.64SR6
X
X
X
EX II series
Serial resistive series
MT 7.11SR1
X X All
current
controllers
(serial and USB)
MicroTouch software includes the touch screen driver and control
panel that enables your touch screen to work with your computer.
Once the software is installed, restart your computer to load and
activate the touch screen driver. To complete the setup of your touch
monitor, make sure you calibrate the touch screen.
Calibrating the Touch Screen
After you connect your touch monitor and install TouchWare, you
must calibrate the touch screen.
Calibration
serves two purposes:
•
Sets the active area of the touch screen
•
Aligns the touch screen’s active area to the underlying video