Chapter 3 Setting Up Your CT150 Monitor
17
3M Touch Systems Proprietary Information
Clearance and Ventilation
Leave at least two inches of clearance space behind the CT150
monitor for proper ventilation. Units have vent holes at the top and
bottom on the back of the chassis -- ensure these holes are not
blocked during installation. Always maintain adequate ventilation to
protect the display from overheating and to ensure reliable and
continued operation. Refer to the published specifications for the
maximum and minimum operating temperature and humidity
conditions.
Securing and Routing System Cables
You must be sure to secure all cable connections. Shaking and
vibration, especially during shipment, may dislodge components that
are improperly connected.
•
Be sure to tighten all cable screws.
•
Route all wiring and cabling away from heat sources and sharp metal
edges to avoid damage. Also, keep the touch screen cable away from
sources of electromagnetic and radio frequency interference.
Installing the Video Card and Video Driver
Before you can connect your touch monitor, make sure your
computer has a video card already installed for the monitor. After
you connect the monitor, you need to install the video software
driver. The video driver is supplied by the video card manufacturer
and may be found on the CD that came with your computer. If you
need information on installing a video card or video driver, refer to
the manual that came with your video card.
Supported Video Display Modes and Refresh Rates
Your video card must support one of the display modes specified in
Table 1. If you select an unsupported video mode, the monitor will
stop working or display an unsatisfactory picture quality.