3M HEADSET C1060, Руководство по эксплуатации

Страница: 21 / 34

Model C1060 Maintenance

3M 2001 February
15
The battery charger should be placed on a flat surface such as a desktop or table
in a clean, dry environment.
If the indicators fail to light during charger operation, clean the contacts using an
alcohol–moistened cotton swab.
Avoid dropping batteries.
Do not carry batteries in your pockets or leave them in hot, damp or dirty places.
Clean the battery contacts periodically using an alcohol–moistened swab.
Be careful not to short the battery contacts together.
Do not set the batteries contact–side down on a bare metal countertop.
When the battery voltage becomes too low, a short, low–volume tone sounds in
the headset at seven–second intervals to alert the operator to replace with a fully
charged battery.
The “ battery voltage low tone” continues for two minutes after which the
headset turns off automatically to prevent damage to the batteries.
To charge a battery, insert the battery in one of the charging slots as shown in
Figure 13.
•
The indicator lights RED to indicate the battery is charging.
•
The indicator lights GREEN to indicate the battery is charged.
ü
Note
Discharged batteries require 1–1/2 to 2 hours to charge.
ü
Note
When the GREEN indicator lights, the battery is approximately 80% charged.
An additional 1/2 hour of charging is required to achieve maximum charge.
Charging
Status
Indicator
Figure 13.
Location
Cleaning the Contacts
Batteries
Care, Handling and
Storage
Low Battery Tone
Charging Batteries
Battery Charger