13
ESD Events Sensor – Display and Controls
For the detection of most ESD events using CDM, MM or HBM models.
Settings and Displays
18
(denotes a touch screen feature)
POWER C
Press the “Power C” button to:
1) Clear or reset the screen data (momentarily
press)
2) Turn the meter OFF (long press for 4 seconds)
MENU F
Press the “Menu F” button to:
1) Adjust brightness
2) Adjust auto-OFF-time
3) Select antenna options
NAVIGATOR
Press the arrow buttons to:
1) Increase or decrease value settings
2) Move fields or cursor around the setup screen
3) Return to the main screen by pressing the
center arrow
HOLD
Press the “Hold” button to:
1) Freeze the display (the “Hold” symbol appears)
2) Freeze maximum values (press twice for the
“Max” symbol to appear)
DATA STORAGE
Press to read the data from the memory card
TRUE-ESD
TRUE-ESD mode, toggle to enable ESD FILTER
mode
ALL-SIGNAL
ALL-SIGNAL mode, toggle to enable ALL SIGNAL
mode
BATTERY
Battery level display
TIME
Displays time, press to setup
ESD MODE
Press to set calculations for CDM, MM or HBM
models. Also sets the distance to the ESD target
COUNTER
Counter display for ESD events detected
THRESHOLD BAR
Displays relative amplitude level of detected ESD
events. Green means the ESD event is below set
threshold, Red means the ESD event is above
threshold. Press this button to adjust the ESD
event threshold voltage
AUDIO
Selectable audio mode
Tone (bell), speaker/volume and mute
VOLTAGE
DISPLAY
Displays the estimated voltage readout of the
ESD event or other signals as detected through
the antenna
